The production process of the eight-pronged work stool!
The stool surface uses hidden tenons to connect the stool legs! The mortise and tenon joints do not need to be glued, but are tightly driven into the tenons. No clamps are used!
The stool surface does not have a belt. Use two 8cm*3cm*1cm Pontianak hidden tenons to splice the stool surface. Put 4 stainless steel screws on the bottom of the stool surface and tighten them (see the 4th figure from the bottom)!
Use an inch and a half oblique line. If the legs are too slanted, it will not look good!

Throw the wood into the air. The wood will automatically reverse quickly in the air. Then take it in your hand and put it down and plan it again! I believe many wood friends understand it. But if you are not skilled, it is easy to hurt people. Be careful!



Unified reply. Thank you all wood friends for your attention and praise

This post was last edited by Yihai Tongdao on 2016-11-21 14:23